Pay attention to the lathe equipment when stamping parts are processed! Stamping parts processing is a project that our company has been engaged in for many years, and the effect is better in the market.

The main points for attention of lathe equipment for stamping parts processing are as follows: Don't open the cuffs and wear tight protective clothes. Protective caps should be worn for long hair and gloves should not be worn for operation. The chuck and flower disc must have stable bolts, which should be tightened before use, and the tapered shaft chuck should be equipped with pull rods. Before operation, check the working condition of the lathe, find out the problems and deal with them in time. Fix the workpieces and cutters tightly. The protruding parts of chucks, dials and chicken core clamps that hold workpieces are best protected by protective shields to avoid hanging clothes and other parts of the body. If there is no protective cover, the operation should pay attention to the interval, do not approach. It is forbidden to wrap sand cloth by hand or polish parts with cotton sand when the workpiece changes. It is necessary to wrap sand cloth with mallet when sanding inner hole and outer circle. For cutting strip chips and spiral long chips, use hooks to eradicate them in time. Hand pulling is forbidden. In addition to the active measuring equipment installed on the lathe, the workpiece should be parked and measured, and the tool holder should be moved to safety. When turning slender workpieces, the middle frame or heel frame should be selected for safety, and the part growing out of the lathe should be marked. In order to prevent debris from breaking and chipping, it is necessary to equip clear baffles in appropriate directions.